Filter
Top Products
14
MAKING AND RECEIVING
CALLS
To make a call, lift the handset and
press
TALK
.
Talk
and the current vol-
ume setting (see “Adjusting the Handset
Volume”) appear on the handset’s dis-
play, and the CHARGE/IN USE indicator
on the base lights. Then dial the num-
ber. The number displays on the hand-
set as you dial, then (after a few
seconds) the call’s elapsed time dis-
plays.
You can also dial the number before you
press
TALK
.
If you make a mistake, press
DELETE
until the incorrect entry is erased, then
enter the correct number. To delete the
entire number, hold down
DELETE
for at
least 2 seconds.
When you receive a call,
Incoming
Call
appears on the display. To an-
swer it, lift the handset from the base
and press
TALK
. If auto talk is on, just lift
the handset from the base. If the hand-
set is away from the base, press any
key.
Talk
and the current volume set-
ting appear on the display.
To end a call, place the handset on the
base or press
TALK
.
SELECTING THE
CHANNEL
The phone has 20 channels. If the call
seems to disconnect for no reason dur-
ing a call, press
CH/SELECT
on the
handset to select a different channel.
The display shows
Scanning
as your
phone searches for a clear channel.
ADJUSTING THE
HANDSET VOLUME
To adjust the volume of the sound you
hear through the handset during a call,
press
VOL/CID
or on the handset
until you obtain the desired volume lev-
el.
Volume
Maximum
,
Volume
High
,
Volume
Medium
, or
Volume
Low
displays on the handset.
Once you set the volume level, the set-
ting is maintained even after you hang
up the phone.
Note:
When you press
VOL/CID
while
the volume is maximum or while the
volume is low, the setting does not
change and an error tone sounds.
USING REDIAL
You can quickly dial any of the last three
numbers you dialed recently. Lift the
handset and repeatedly press
REDIAL/
PAUSE
until the number you wish to dial
displays. Then press
TALK
and the
phone dials the number.
CHARGE/
IN USE