Filter
Top Products
10
• If the display is blank and the phone
does not work, recharge the battery
pack. (The battery power might be
too low to light the display.)
• If you are not going to use your
phone for an extended period of
time, disconnect the battery pack.
This increases the battery pack’s
usable life.
• The supplied battery pack should
last about a year. When it loses its
ability to fully recharge, order a re-
placement battery pack from your
local RadioShack store (see “Re-
placing the Battery Pack” on
Page 25).
SETTING THE
DIALING MODE
Set
DIAL MODE
on the back of the base
for the type of service you have. If you
are not sure which type you have, do
this test after you charge the handset’s
battery pack.
1. Set
DIAL MODE
to
T
(tone).
2. Lift the handset, press
TALK
, and
listen for a dial tone.
3. Press any number other than
0
.
Note:
If your phone system requires
that you dial an access code (9, for
example) before you dial an outside
number, do not press the access
code, either.
If the dial tone stops, you have
touch-tone service. Leave
DIAL
MODE
set to
T
.
If the dial tone continues, you have
pulse service. Leave
DIAL MODE
set
to
P
(pulse).
4. Press
TALK
or place the handset on
the base to hang up.
SETTING THE RINGER
TONE/VOLUME
You can select one of four different ring-
er tone/volume settings on the handset.
At any time, except during a call, repeat-
edly press
VOL/CID
or to select the
desired ringer setting. Each time you
press a button, the phone rings at the
selected setting and the display shows
Ringer
A
High
,
Ringer
A
Low
,
Ringer
B
High
, or
Ringer B Low
.
Note:
Pressing
VOL/CID
at
Ringer
A
High
or
VOL/CID
at
Ringer
B
Low
does not change the setting. Press
the opposite arrow key to change the
setting.
DIAL MODE