Filter
Top Products
8
Preparation
Installing the Battery Pack
The supplied battery pack, when fully
charged, provides power to your trans-
ceiver for up to 8 hours. You must install
the battery pack in your transceiver, then
charge it.
Caution: Do not remove the plastic wrap
from the battery pack. Doing so can per-
manently damage the battery.
Follow these steps to install the battery
pack.
1. Unlock the battery compartment
cover by sliding both of the cover’s
latches toward the front of the trans-
ceiver as shown. Then slide the
cover in the direction of the arrow
and lift it off.
2. With the battery printing facing up,
align the contacts on the battery
pack with the contacts inside the
battery compartment. Then, press
illus - show bat comp cover
latches being released and
cover being slid down
the battery pack into the compart-
ment while applying slight pres-
sure to the bottom of the battery
pack.
3. Slide the battery cover back into
place, then slide both of the
latches toward the back of the
transceiver to lock it.
To remove the battery pack, unlock the
compartment, then turn the transceiv-
er face down and gently tap it into your
palm so the battery pack slides out.
illus - show battery pack
being installed into
compartment
19-1206.fm Page 8 Tuesday, August 3, 1999 10:50 AM