Filter
Top Products
15
4. Hold down PUSH TO TALK, then
turn VOLUME clockwise until it
clicks. The transceiver sets the
CTCSS code. Release PUSH TO
TALK.
If the transceiver beeps once and
RX/TX lights green for about 2
seconds, that means the CTCSS
setting was successful.
If the transceiver beeps 3 times
and RX/TX lights red for about 2
seconds, the CTCSS setting did
not work. Start over at Step 1.
5. To activate the CTCSS code you
set, set the first DIP switch to 1
26 162.2 011010
27 167.9 011011
28 173.8 011100
29 179.9 011101
30 186.2 011110
31 192.8 011111
32 203.5 100000
33 210.7 100001
34 218.1 100010
35 225.7 100011
36 233.6 100100
37 241.8 100101
38 250.3 100110
CTCSS
(up). To deactivate the code, set the
switch to 0 (down).
6. Replace the battery compartment
cover.
19-1206.fm Page 15 Tuesday, August 3, 1999 10:50 AM