Filter
Top Products
Installation
11
The supplied battery pack should last about a year.
If the battery pack does not hold a charge for more
than 2 hours after an overnight charge, replace it
with a new 3.6V, 600 mAh battery pack with a
connector that fits the socket in the battery
compartment. You can order a replacement battery
pack through your local RadioShack store (or online
at RadioShack.com). Install the new battery pack
and charge it for about 24 hours.
o
If you have trouble replacing the battery pack, take
the phone to your local RadioShack for assistance.
Recycling Ni-Cd Batteries.
The EPA certified RBRC
®
Battery
Recycling Seal on the nickel-cadmium
(Ni-Cd) battery indicates RadioShack
is voluntarily participating in an industry
program to collect and recycle these
batteries at the end of their useful life, when taken
out of service in the United States or Canada. The
RBRC program provides a convenient alternative to
placing used Ni-Cd batteries into the trash or the
municipal waste stream, which may be illegal in
your area. Please call 1-800-THE-SHACK (1-800-
843-7422) for information on Ni-Cd battery
recycling and disposal bans/restrictions in your
area. RadioShack’s involvement in this program is
part of the company’s commitment to preserving
our environment and conserving our natural
resources.
CHOOSING THE DIALING MODE Ô
Most phone systems use tone dialing which sends
standard tones through the phone lines. However,
some phone systems still use pulse dialing such as
in rural areas. The default setting is tone dialing.
Depending on your dialing system, set the mode as
follows:
o
WARNING
o
Dispose of the old battery
pack promptly and properly.
Do not burn or bury it (see
“Battery Safety Instructions”
on Page 4 for additional
information on proper
battery handling).
Ô NOTE Ô
• If you are not sure of
your dialing system,
make a trial call. If the
call connects, leave the
setting as is, otherwise
set for pulse dialing.
• If your phone system
requires pulse dialing
and you need to send
the standard tones for
certain situations during
a call, you may “switch-
over” to tone dialing
(refer to “Tone Dialing
Switch-over” on page
13).
43-3823.FM Page 11 Thursday, March 27, 2003 10:22 AM