Filter
Top Products
Installation
9
1. Plug one end of the supplied short
modular cord into the
TEL LINE
jack on
the bottom of the base.
2. Plug the supplied AC adapter's barrel
plug into the
DC IN 9V
jack.
3. Route the adapter
and modular cords
through the
grooves on the
back of the base.
4. Plug the adapter
into a standard AC
outlet. And plug
the other end of the modular cord into a
modular phone line jack.
5. For a wall plate, align the keyhole slots
on the bottom of the base with the wall
plate studs and slide the base
downward to secure it.
For direct wall mounting, align the
base's keyhole slots with the mounting
screws and slide the base downward to
secure it.
C
ONNECTING
/C
HARGING
THE
BATTERY PACK
The phone comes with a rechargeable
nickel-cadmium battery pack in the handset,
but not connected. Before using your
phone, you must connect the battery pack.
Then charge it for about 15–20 hours.
!
1. Press down and slide the battery
compartment cover off of the handset.
2. Lift the battery pack out of the
compartment.
TEL LINEDC IN 9V
!
IMPORTANT
!
The EPA
certified
RBRC
®
Battery
Recycling Seal
on the nickel-
cadmium (Ni-Cd) battery
indicates RadioShack is
voluntarily participating in
an industry program to
collect and recycle these
batteries at the end of their
useful life, when taken out
of service in the United
States or Canada. The
RBRC program provides a
convenient alternative to
placing used Ni-Cd
batteries into the trash or
the municipal waste
stream, which may be
illegal in your area. Please
call 1-800-THE-SHACK (1-
800-843-7422) for
information on Ni-Cd
battery recycling and
disposal bans/restrictions
in your area. RadioShack’s
involvement in this
program is part of the
company’s commitment to
preserving our
environment and
conserving our natural
resources.
43-3595.book Page 9 Monday, June 7, 2004 2:27 PM