Radio Shack 43-3557 Cordless Telephone User Manual


 
Additional Information
32
ADDITIONAL
INFORMATION
INSTALLING THE BELTCLIP
To attach the beltclip
Insert the beltclip into the holes on each
side of the handset. Press down until it
clicks.
To remove the beltclip
Pull both sides of the beltclip to release the
tabs from the holes.
HEADSET INSTALLATION
You can connect an optional headset with a
3
/32-inch (2.5-mm) plug. Contact
RadioShack for a suitable headset.
To connect the headset, open the rubber
cover on the side of the handset. Then
insert the headset’s plug into the jack.Ô
When you finish using the headset,
disconnect it from the handset and close the
rubber cover to protect the jack.
Ô NOTES Ô
If you place the handset
on the base to recharge
it while the headset is
connected, be sure the
handset seats properly.
You can use a handset
holder (available from
your local RadioShack
store) to hang the
handset on your belt for
greater convenience
when using a headset.
43-3557.book 32 ページ 2003年12月17日 水曜日 午後4時54分