Radio Shack 43-327 Cordless Telephone User Manual


 
6
Telephone Setup
Battery Installation and Charging
Install the battery as shown below. For best performance, charge the
handset for at least 16 hours before use. When not in use, place the handset
in the telephone base or charger. See page 41 for battery operating times.
1. If the battery compartment cover is on the handset, press the
indentation and slide the cover to remove.
2. Plug the battery securely into the plug inside the handset battery
compartment, matching the color-coded label.
3. Place the battery with the label THIS SIDE UP facing up and the wires
inside the battery compartment.
4. Align the cover flat against the battery compartment, then slide it
towards the center of the handset until it clicks into place.
5. Charge the handset by placing it in the telephone base or charger. The
CHARGE light is on when the handset charges.
n Notes:
When the screen shows LOW BATTERY, the backlight is off.
If the handset will not be used for a long time, disconnect and remove
the battery to prevent possible leakage.
To purchase replacement batteries, visit your local RadioShack store or
go to www.RadioShack.com.
Match with
color code label
Red wire
Black wire