Radio Shack 43-327 Cordless Telephone User Manual


 
42
Additional Info
Expanding your Telephone System
The handsets provided with your telephone system are pre-registered.
Each handset is assigned a number that shows on the handset display.
Additional handsets registered to the telephone system are assigned in
sequential order. For instance, if the telephone system already has HANDSET
1 and HANDSET 2, the new registered handset is assigned HANDSET 3. This
telephone system accommodates up to 12 handsets.
Add and Register a Handset (Optional)
You can add new handsets (purchased separately) to your telephone
system, but each handset must be registered with the telephone base
before use. When first purchased, each expansion handset shows NOT
REGISTERED.
To make registration easier, read all of the instructions on this page before
you begin. If the handset screen does not show LOW BATTERY or HANDSET
X, you will need to charge the handset for at least five minutes before
registering to the telephone base.
To register a handset:
1. Place the unregistered handset in the telephone base or charger. If
PRESS FIND HS 4 SEC ON BASE does not appear on the handset
screen after a few seconds, remove the handset and place it in the
telephone base or charger again.
2. On the telephone base, press and
hold FIND HANDSET for about four
seconds (until the red IN USE light on
the telephone base turns on) and then
release the button. The handset shows
PLEASE WAIT... and it takes about 10
seconds to complete the registration.
The handset shows HANDSET X
REGISTERED (X represents the handset
number assigned) and you hear a beep
when the registration completes.
n Notes:
If the registration fails, the handset shows NOT REGISTERED. To reset
the handset, remove the handset from the telephone base and place it
back in. Try the registration process again.
You cannot register a handset if any other system handset is in use.