Filter
Top Products
Installation
12
• If the base loses power for about an
hour while the handset is away from it,
the security access-protection code
might be lost. To change the code,
while holding
PAGE, return the handset
to the base for about 3 seconds.
• If the battery pack becomes weak
during a call, the handset beeps every
3 seconds and
LL
LL
oo
oo
ww
ww
BB
BB
aa
aa
tt
tt
tt
tt
ee
ee
rr
rr
yy
yy
flashes.
When this happens, you cannot make a
call until you recharge the battery
pack.
!
• If the display is blank and the phone
does not work, recharge the battery
pack. (The battery power might be too
low to light the display.)
• About once a month, fully discharge the
battery by keeping the handset off the
base until
LL
LL
oo
oo
ww
ww
BB
BB
aa
aa
tt
tt
tt
tt
ee
ee
rr
rr
yy
yy
flashes on
the display. Otherwise, the battery pack
loses its ability to fully recharge.
• The handset loses its security access-
protection code if the battery pack is
completely discharged. While holding
PAGE, place the handset on the base to
recharge the battery pack and change
the code.
• Using a pencil eraser, clean the
charging contacts on the handset and
base about once a month.
• If you are not going to use your phone
for an extended period, disconnect the
battery pack. This increases the battery
pack’s usable life.
!
IMPORTANT
!
Be sure the battery pack is
properly connected before
you try to charge it. The
CHARGE/IN USE indicator
lights when the handset is
on the base, even if the
battery pack is not
connected.
43-3548.fm Page 12 Tuesday, February 25, 2003 1:06 PM