Filter
Top Products
Installation
10
4. Plug the adapter into a standard AC
outlet.
5. Lift the base’s antenna to a vertical
position.
On a Wall
To mount the phone directly on a wall, you
need two screws (not supplied) with heads
that fit into the keyhole slots on the bottom
of the base.
1. Drill two holes 3
15
/16 inches (100 mm)
apart. Then thread a screw into each
hole, letting the heads extend about
1
/8
inch (3 mm) from the wall.
2. Plug one end of the supplied long
modular cord into the
TEL LINE jack on
the back of the base.
3. Insert the supplied AC adapter’s barrel
plug into the
DC IN 9V jack on the back
of the base.
4. Route the adapter and modular cords
through the grooves on the bottom of
the base.
5. Align the base’s keyhole slots with the
mounting screws and slide the base
downward to secure it.
6. Plug the modular cord’s other end into
the phone jack, and plug the adapter
into a standard AC outlet.
7. Lift the base’s antenna to a vertical
position.
43-3548.fm Page 10 Tuesday, February 25, 2003 1:06 PM