Filter
Top Products
8
4. Route the adapter’s cord through
the strain relief slot on the back of
the phone.
5. Insert the bracket’s two small tabs
into the matching slots near the top
of the phone and snap the bracket
into place.
6. Plug the other end of the modular
cord into a modular phone line jack.
7. Plug the adapter into a standard AC
outlet.
Strain
Relief Slot
On a Wall or Wall Plate
Note:
To mount the System
1250 directly on a wall, you
need two screws (not sup-
plied) with heads that fit the
keyhole slots on the bottom
of the phone. Drill two holes
3
15
/
16
inches (100 mm) apart.
Then thread a screw into
each hole, letting the heads
extend about
5
/
16
inch (7
mm) from the wall.
1. Remove the mounting bracket by
holding in the tab on the right side of
the bracket and gently pulling out
the bracket.
2. Insert the bracket’s two small tabs
into the matching slots near the bot-
tom of the phone and snap the
bracket into place.
5
/
16
"
3
15
/
16
"
43-986.fm Page 8 Monday, August 16, 1999 5:16 PM