Polycom 5020 Telephone User Manual


 
Polycom, Inc. 71
Polycom Kirk 5020-5040 User Guide General Information
5 Do not use non-Nortel charging devices. This could damage the batteries
Notices
Before installing this equipment, users should ensure that it is permissible to be
connected to the facilities of the local telecommunications company. The
equipment must also be installed using an acceptable method of connection.
The customer should be aware that compliance with the above conditions may
not prevent degradation of service in some situations.
Repairs to certified equipment should be coordinated by a representative
designated by the supplier. Any repairs or alterations made by the user to this
equipment, or equipment malfunctions, may give the telecommunications
company cause to request the user to disconnect the equipment.
Users should ensure for their own protection that the electrical ground
connections of the power utility, telephone lines and internal metallic water
pipe system, if present, are connected together. This precaution may be
particularly important in rural areas
CAUTIONS: Users should not attempt to make such connections themselves,
but should contact the appropriate electric inspection authority, or electrician,
as appropriate.
If your telephone equipment causes harm to the telephone network, the
telephone company may ask you to disconnect the system from the line until
the problem has been corrected or they may discontinue your service
temporarily. If possible, they will notify you in advance, But if advance notice
is not practical, you should be notified as soon as possible. You will be informed
of your right to file a complaint with the FCC.
Your telephone company may make changes in its facilities, equipment,
operations, or procedures that could affect the proper functioning of your
telephone system, If they do and it is possible, you will be notified in advance
to give you an opportunity to maintain uninterrupted telephone service. If you
experience trouble with this telephone system, disconnect it from the network
until the problem has been corrected or until you are sure that the equipment
is not malfunctioning.
Note: This equipment has been tested and found to comply with the limits for
a class B digital device, pursuant to local regulations. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more
of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.