Filter
Top Products
29
Advanced settings
free talk mode. This allows you to charge
the handset during calls.
The default setting for auto hang up is
ON.
1 Press m in idle mode, scroll n to
PERSONAL SET and press o.
2 Scroll n to AUTO HANG-UP
and press o. The current setting
is shown.
3 Scroll n to select ON or OFF and
press o to confirm.
• A validation tone is emitted and
the screen returns to the
AUTO HANG-UP menu.
7 Advanced settings
7.1 Change PIN
The PIN is used for registration/
unregistration of handsets. The default
PIN number is 0000. The maximum
length of the PIN is 4 digits. This PIN is
also used to protect the settings of your
handset. Your handset will prompt you
whenever the PIN is required.
The default pin code is preset to 0000. If
you change this PIN code, keep the PIN
details in a safe place where you have
easy access to them. Do not lose the PIN
code.
1 Press m in idle mode, scroll n to
ADVANCED SET and press o,
and then press o again to enter
CHANGE PIN.
2 Enter the current PIN when
prompted and press o to confirm.
• The PIN entered will be shown
as asterisks (*) on the screen.
3 Enter the new PIN and press o to
confirm PIN change. A validation
tone is emitted and SAVED
appears for a moment, and then the
screen returns to the idle screen.
If you forget your PIN, you will need to
reset your phone to its default settings.
See section 7.5 “Reset Unit” for more
details.
7.2 Register
If you wish to register an additional
handset or if you have inadvertently
unregistered your phone's handset and
want to re-register it, follow the
procedure described below. This is the
procedure for registering handsets of
one of the model described in this
manual. Procedures may vary for other
types of handsets. In this case, please
refer to the manufacturer of the handset.
Additional handsets must be registered
to the base unit before you can use them.
Up to 5 handsets can be registered to
one base station.
The PIN is required before you can
register or unregister handsets.
By default, the PIN is 0000.
1 On the base station, press and hold
a for approximately 3 seconds. A
beep is emitted to indicate that the
Note
Tip
Note