IPD4-A2-GZ40-00 February 2005 15
Securing the Connecting Cables
Position all connecting cables such that they will not become a tripping hazard or
pull loose from the chassis; secure with cable ties or hook-and-loop fastener
straps.
Configuration and Management
Although no configuration is necessary to run subscriber lines at the default
settings, all 4000E parameter settings are software selectable via Command Line
Interface (CLI), Simple Network Management Protocol (SNMP), and/or the
Network Management System (NMS). 4000E management capabilities depend
upon the management module model installed in your chassis. Once the
management module has been initialized, the interface modules installed in your
4000E may also be configured as desired. Refer to the following for further
information:
Document Contents
Management module
installation instructions
(model-specific)
module installation
port pinouts
parameter defaults
parameter configuration options
management system capabilities
Uplink module installation
instructions
(model-specific)
module installation
port pinouts
parameter defaults
parameter configuration options
Interface module user
guides
(model-specific)
module installation
distance and bandwidth capabilities
port pinouts
parameter defaults
parameter configuration options
CLI Management User
Guide
management module initialization instructions
command user guide
command definitions
configuration options common to all management
module models
configuration options common to all interface module
models
NMS Management User
Guide
management module initialization instructions
screen by screen user guide
parameter definitions
configuration options common to all management
module models
configuration options common to all interface module
models