Filter
Top Products
26
Preparing the Answering System
Selecting the Number of Rings
You can select the number of times the unit rings before the answering
system answers a call, from “2” to “7” or “Toll saver”*.
Your phone comes from the factory set to “3”.
1
Press (FUNCTION/CH).
2
Press Ö or Ñ repeatedly until the arrow
points to “Program”.
3
Press á (Yes key).
4
Press Ö or Ñ repeatedly until the arrow
points to “TAD program”.
5
Press á (Yes key).
•The base unit display shows programming
options.
6
Press (2).
•The current setting is displayed on the base
unit.
7
Press (0), or (2) to (7) to set the number of rings.
0: Selects “Toll saver”*.
2–7: The unit will answer after the selected number of rings.
•The unit will announce a caller’s name after the 2nd ring (Talking Caller ID
feature, p. 34).
To listen to the name announcements, do not select “2”.
8
Press á (Save key).
•A beep sounds.
•To return to the standby mode, press (OFF).
*Toll saver
When you call the unit from a touch tone telephone:
If the unit answers on the 3rd ring, there is at least one new message.
If the unit answers on the 5th ring, there are no new messages.
Hang up when you hear the 4th ring. This will save you the toll
charge for the call.
H
Program
Calling pager
GF H
=Yes
H
Save DIRECT#
Set flash time
GF H
=Yes
Set dial mode
H
TAD program
GF H
=Yes
Answering
system setting.
See base unit.
H
Save directory
Ringer volume
GF H
=Yes
Number of rings
:3
Base unit display