Filter
Top Products
Y
Programming using the Handset
25
Document Version 2011-03
Programmable settings
You can customize the unit by programming the following features.
To access the features, there are 2 methods:
– scrolling through the display menus (page 25)
– using the direct commands (page 26)
Some of the features can be programmed through the Web user interface (page 39).
L Direct command is the main method used in this User Guide.
Programming by scrolling through the display menus
1
{MENU} (center of joystick)
2 Select the desired main menu by pushing the joystick in any direction. i {SELECT}
3 Push the joystick down or up to select the desired item in sub-menu 1. i {SELECT}
L In some cases, you may need to select from sub-menu 2. i {SELECT}
4 Push the joystick down or up to select the desired setting. i {SAVE}
L This step may vary depending on the feature being programmed.
L To exit the operation, press {OFF}.
Note:
L See page 26 for the default settings.
L In the following table, ( ) indicates lines you need to select for the settings.
Main menu Sub-menu 1 Sub-menu 2 Page
Line status
m
––9
IP service Network setting DHCP
*1
–
IP settings
*1
–
Embedded web 39
Call features Call forward
(Line 1: 8 max.)
– Unconditional
*1
– Busy
*1
– No answer
*1
28
Do not disturb
*1
(Line 1: 8 max.)
29
Block anonymous
*1
(Line 1: 8 max.)
29
Block Caller ID
*1
(Line 1: 8 max.)
30
New Voice Mail
#
––43
Intercom
x
– – 44, 45