Filter
Top Products
*2 If you program these settings using one of the units, you do not need to program the same
i
tem using another unit.
*3 This menu is not displayed when scrolling through the display menus. It is only available in
direct command code.
*4 KX-TGE240 series: page 3
*5 This feature allows the unit to automatically adjust the date and time each time caller
information including date and time is received.
To turn this feature on, select “Caller ID auto”. To turn this feature off, select
“Manual”. (Caller ID subscribers only)
To use this feature, set the date and time first (page 14).
*6 If you subscribe to a distinctive ring service (such as IDENTA-RING), select a tone (tone 1 to
3). If you select a melody, you cannot distinguish lines by their ringers.
*7 The preset melodies in this product are used with permission of © 2009 Copyrights Vision
Inc.
*8 This setting is available when you have the key detector (KX-TGA20). Read the installation
manual for more information on the key detector.
*9 For models with supplied key detectors, the display shows “1: Detector1”.
*10 If you register 2 or more key detectors.
*11 If you have 2 or more key detectors.
*12 If you subscribe to a Caller ID service and want to view the caller’s information after lifting up
the handset to answer a call, turn off this feature.
*13 The flash time depends on your telephone exchange or host PBX. Contact your PBX
supplier if necessary. The setting should stay at “700 ms” unless pressing MFLASHN fails to
pick up the waiting call.
*14 Generally, the line mode setting should not be changed. This setting automatically maintains
receiver volume at the proper level depending on the current telephone line condition. Set
the line mode to “A” if telephone line condition is not good.
Alarm
A
n alarm sounds at the set time for 1 minute
and is repeated 5 times at 5 minute intervals
(snooze function). A text memo can also be
displayed for the alarm. A total of 3 separate
alarm times can be programmed for each
handset. You can set one of 3 different alarm
options (once, daily, or weekly) for each alarm
time.
Important:
R Make sure the unit’s date and time setting
is correct (page 14).
1 MMENUN#720
2 Select an alarm by pressing 1 to 3. a
MSELECTN
3 MbN:
Select the desired alarm option. a
MSELECTN
“O
ff”
Turns alarm off. Go to step 10.
“O
nce”
An alarm sounds once at the set time.
“D
aily”
An alarm sounds daily at the set time.
Go to step 5.
“W
eekly”
Alarm sounds weekly at the set time(s).
4 P
roceed with the operation according to
your selection in step 3.
n Once:
Enter the desired month and date. a
MOKN
32
For assistance, please visit http://www.panasonic.com/help
Programming
TGE21x23x24x(en)_1122_ver031.pdf32 32 2013/11/22 14:22:28