Filter
Top Products
Making an intercom call
Handset
1 MM
ENUN a MbN: “Intercom” a
MSELECTN
2 MbN: Select the desired unit. a MSELECTN
3 When you finish talking, press MOFFN.
Note:
R You can also use the MINTN soft key, if
displayed, to make intercom calls.
Base unit
*
1
*1 KX-TGE240 series: page 3
1 Press MINTERCOMN.
When 2 or more handsets are
registered:
– To page a specific handset, enter the
handset number.
– To page all handsets, press 0 or wait
for a few seconds.
R To stop paging, press MINTERCOMN.
2 When you finish talking, press
MINTERCOMN.
Answering an intercom call
Handset
1 P
ress M
N
to answer the page.
2 When you finish talking, press MOFFN.
Base unit
*
1
*1 KX-TGE240 series: page 3
1 Press MINTERCOMN to answer the page.
2 When you finish talking, press
MINTERCOMN.
Using the Smart function key
P
ress M
N
to answer the page.
Power back-up operation
W
hen a power failure occurs, the charged
handset temporarily supplies power to the
base unit (power back-up mode). This allows
y
ou to make and receive calls using a handset
during a power failure. The base unit will not
perform any other functions. However, some
functions such as Caller ID and phonebook
are available only when using a handset other
than the handset supplying power to the base
unit. You can program “Power failure”
and the default setting is “Auto” (page 31).
Important:
R If a handset is not placed on the base unit
when a power failure occurs, “Base no
power Press OFF” is displayed. After
pressing MOFFN on the handset, place it on
the base unit to start power back-up mode.
R Power back-up mode will not work if the
battery level of the power supplying
handset is
or .
R D
o not lift the power supplying handset
from the base unit during power back-up
mode.
Panasonic Ni-MH battery
p
erformance (supplied batteries)
during power back-up mode
When the batteries are fully charged,
operating time of the handset in power
back-up mode varies depending on usage.
– Continuous use of the handset in power
back-up mode: 1.5 hours max.
– Continuous use of the handset other than a
handset in power back-up mode: 2 hours
max.
– Not in use in power back-up mode: 2 hours
max.
Making calls during a power
failure
n When only 1 handset is registered:
1 Lift the handset and dial the phone
number.
2 Within 1 minute, place the handset on
the base unit.
R Wait until speakerphone is turned
on automatically and the call is
made.
22
For assistance, please visit http://www.panasonic.com/help
Making/Answering Calls
TGE21x23x24x(en)_1122_ver031.pdf22 22 2013/11/22 14:22:27