Setting up
Connecting the AC adaptor
n Base unit
Connect the AC adaptor plug to the unit until
you hear a click.
Connect the AC adaptor to the power outlet.
Note:
R Use only the supplied Panasonic AC adaptor
PNLV234.
R Follow the directions on the display to set up
the unit.
n Charger
Connect the AC adaptor to the power outlet.
Connecting the telephone line cord
Refer to one of the following methods depending
on your situation:
– To connect to a 2-line telephone jack: page 9
– To connect to 2 single-line telephone jacks:
page 9
– If you use the unit as a single-line telephone
only: page 9
Connect the telephone line cord until it clicks into
the base unit and telephone line jack.
To connect to a 2-line telephone jack
Connect the “GREEN” plug telephone line
cord (4-wire cord) (
) to the unit, then to the
2-line telephone jack (RJ14C) (
To connect to 2 single-line telephone jacks
For Line 1: Connect the “Transparent” plug
telephone line cord (2-wire cord) (
) to the
unit, then to the Line 1 single-line telephone
jack (RJ11C) (
) until you hear a click.
For Line 2: Connect the “GREEN” plug
telephone line cord (4-wire cord) (
) to the
unit, then to the Line 2 single-line telephone
jack (RJ11C) (
) until you hear a click.
2
4
3
12
1
“Transparent” plug
“GREEN”
plug
If you use the unit as a single-line telephone
only
Be sure to connect the telephone line cord to LINE
1/2. Change the line selection mode from “Auto”
to “Line1” (page 17).
Connect the “Transparent” plug telephone line
cord (2-wire cord) (
) to the unit, then to the
single-line telephone jack (RJ11C) (
For assistance, please visit http://www.panasonic.com/help
9
Getting Started
TG954x(en)_0628_ver031.pdf 9 2013/06/28 12:35:29
