Filter
Top Products
Handset / Base unit
1 Your headset:
Set your headset to pairing mode.
R Refer to the headset operating instructions.
2 MMENUN#621
3 If your headset PIN is “0000”, go to step 4.
If your headset PIN is other than “0000”,
press MCLEARN, then enter your headset PIN.
R Typically, default PIN is “0000”. Refer to
the headset operating instructions.
4 Press MOKN, then wait until a long beep
sounds.
5 Proceed with the operation for your unit.
Handset: MOFFN
Base unit: MEXITN
R When the HEADSET indicator on the base
unit lights up, the headset is available for
use.
Connecting/disconnecting a headset
If you cannot connect the headset and base unit
using the headset, you can connect using the unit.
To use your headset with another Bluetooth
device such as a cellular phone, you may need to
disconnect it from the base unit.
Important:
R Make sure that the headset is turned on.
Handset
1 To connect/disconnect:
MMENUN#622
R A long beep sounds.
2 MOFFN
Base unit
To connect:
Press MHEADSETN.
To disconnect:
Press and hold MHEADSETN until a long beep
sounds.
Unpairing a headset
You can cancel a pairing of the headset that is
stored to the base unit.
Handset / Base unit
1 MMENUN#612
2 MbN: “Yes” a MSELECTN
R When the headset is unpaired, the
HEADSET indicator on the base unit is
turned off.
3 Proceed with the operation for your unit.
Handset: MOFFN
Base unit: MEXITN
Operating a Bluetooth wireless
headset using a landline
Important:
R Refer to your headset operating instructions for
headset operations.
Answering landline calls with your headset
To answer a landline call, turn on your headset
referring to your headset operating instructions.
When you finish talking, turn off your headset
referring to your headset operating instructions.
Note:
R If you cannot hang up the call using your
headset, press MZN on the base unit 2 times.
Switching between the base unit and your
headset
You can switch between the base unit and your
headset:
– during a landline call with the base unit
speakerphone.
– during an intercom call between the base unit
and handset.
– while listening to messages recorded on the
base unit answering system.
n To switch to your headset:
Press MHEADSETN on the base unit.
n To switch to the base unit:
Press MZN on the base unit.
Call sharing between your headset and the
handset
Important:
R To activate this feature, you should set call
sharing mode to on beforehand (page 42).
n While the handset is on a landline call:
To join the conversation with your headset, turn
on the headset referring to your headset
operating instructions.
52
For assistance, please visit http://www.panasonic.com/help
Using Bluetooth Devices
TG954x(en)_0628_ver031.pdf 52 2013/06/28 12:35:32