Panasonic KX-TG7301NZ Telephone User Manual


 
Useful Information
42
Error messages
If the unit detects a problem, one of the following messages is shown on the display.
*1 KX-TG7321/KX-TG7322
Display message Cause/solution
Answer Sys.
Full
*1
L Erase unnecessary messages (page 32).
Check Tel Line L The supplied telephone line cord has not been
connected yet or not connected properly. Check the
connections (page 12).
Error
*1
L Recording was too short. Try again.
Failed
*1
L Phonebook copy failed (page 22). Confirm the other
handset (the receiver) is in standby mode and try
again.
Incomplete
*1
L The receiver’s phonebook memory is full. Erase the
unnecessary phonebook entries from the other
handset (the receiver) and try again.
Memory Full L The phonebook memory is full. Erase unnecessary
entries (page 21).
L Message memory is full. Erase unnecessary
messages (page 32).
*1
No link to base.
Reconnect AC
adaptor.
L The handset has lost communication with the base
unit. Move closer to the base unit and try again.
L Unplug the base unit’s AC adaptor to reset the unit.
Reconnect the adaptor and try again.
L The handset’s registration may have been cancelled.
Re-register the handset (page 26).
Use rechargeable
battery.
L A wrong type of batteries such as Alkaline or
Manganese was inserted. Use only the rechargeable
Ni-MH batteries noted on page 5, 13.
You must first
subscribe to
Caller ID.
L You must subscribe to a Caller ID service. Once you
receive caller information after subscribing to a Caller
ID service, this message will not be displayed.