Filter
Top Products
Programming
22
1 8 (middle soft key)
2 {V}/{^}: “Base Unit Setup” i
M
3 {V}/{^}: “Base Unit PIN” i
M
4 Enter the current 4-digit base unit
PIN (default: “0000”).
5 Enter the new 4-digit base unit PIN.
i M i {ih}
Incoming call barring (Caller
ID subscribers only)
This feature allows the unit to reject calls
from specified phone numbers that you
do not want to answer such as junk calls.
When a call is received, the unit does not
ring while the caller is being identified. If
the phone number matches an entry in
the call barred list, the unit sends out a
busy tone to the caller, and then
disconnects the call.
Important:
L When the unit receives a call from a
number that is stored in the call barred
list, the call is logged in the caller list
(page 25) with 7 after the call is
disconnected.
Storing unwanted callers
You can store up to 30 phone numbers in
the call barred list by using the caller list
or by entering the numbers directly.
Important:
L You must store the phone number
with an area code in the call barred
list.
■ From the caller list:
1 8 (middle soft key)
2 {V}/{^}: “Caller List” i
M
3 {V}/{^}: Select the entry to be
barred. i 8
4 {V}/{^}: “Add Bar List” i
M
5 {ih}
■ By entering phone numbers:
1 8 (middle soft key)
2 {V}/{^}: “Caller Barred” i
M i ~
3 Enter the phone number (24
digits max.). i M
L To erase a digit, press ^.
4 {ih}
Viewing/editing/erasing bar call
numbers
1 8 (middle soft key)
2 {V}/{^}: “Caller Barred” i
M
3 {V}/{^}: Select the desired entry.
L To exit, press {ih}.
4 Proceed with the desired operation.
■ Editing a number:
8 i {V}/{^}: “Edit” i
M i Press {^} or {V} to move
the cursor. i Edit the number.
i M i {ih}
■ Erasing a number:
8 i {V}/{^}: “Erase” i
M i {V}/{^}: “Yes” i M
i {ih}
Note:
L When editing, press the desired dial
key to add, ^ to erase.
Available for:
KX-TG6421
TG6411-6421BX(e).book Page 22 Monday, April 27, 2009 3:13 PM