Filter
Top Products
26
Day and Time
Voice Day/Time Stamp: During playback, a synthesized voice will
announce the day and time that each message was recorded.
Ringer pattern
H
Program
--------------
--------------
H
TAD program
Set flash time
--------------
H
Day and time
Remote code
1
Press (FUNCTION/2WAY!REC).
2
Scroll to “Program” by pressing Ö or Ñ.
3
Press á.
4
Press á at “TAD program”.
5
Press á at “Day and time”.
•“Set time” is announced from the base unit.
If previously adjusted, the day/time will be heard.
6
Enter the current time (hour and minute)
using a 4-digit number.
(Ex. To set 9:30, enter “0930”.)
7
Press (*) to select “AM” or “PM”.
Press (#) repeatedly to set the day.
8
Press á (Save key).
•The base unit announces the day/time. The clock
starts working.
•If 6 beeps sound from the base unit, the setting is
not correct. Start again from step 5.
•To exit the programming mode, press (OFF)
.
SUN 12:00 AM
#=Day 0-9=Time
=AM/PM
H
=Save
SUN 09:30 AM
#=Day 0-9=Time
=AM/PM
H
=Save
MON 09:30 AM
#=Day 0-9=Time
=AM/PM
H
=Save
Preparing the Answering System
•You can exit the programming mode any time by pressing (OFF).
•In step 6, you cannot enter numbers greater than 12. Do not use military time.
(To set 13:00 hours, enter “0100”, and select “PM” by pressing (*).)
MON 09:30 AM
Make sure the unit is not being used and the handset is lifted off the
base unit.