Filter
Top Products
Preparation
12
L This unit is not designed to be used with
rotary (pulse dialling) services.
Battery installation
1 Insert the batteries negative (T)
terminal first.
2 Close the handset cover.
Note:
L Use only rechargeable batteries (page 5).
Battery charge
Place the handset on the base unit for
about 7 hours before initial use.
When charging, i and battery strength
icon are alternately shown on the display.
When the batteries are fully charged, 1
flashes.
Note:
L It takes 7 hours to fully charge the
batteries, however, you can use the
handset before the batteries are fully
charged.
L Clean the charge contacts (page 9) of the
handset and base unit with a soft, dry
cloth once a month, otherwise the
batteries may not charge properly. Clean
more often if the unit is exposed to grease,
dust or high humidity.
Battery strength
Note:
L When 3 flashes, recharge the handset
batteries. 3 will continue to flash until
the batteries have been charged for at
least 15 minutes.
L If the handset is turned off, it will be turned
on automatically when it is placed on the
base unit.
Battery icon Battery strength
1 High
2 Medium
3 Low
When flashing: Needs
to be charged.
TG1850AL(e).book Page 12 Monday, December 6, 2004 9:10 PM