Filter
Top Products
Answering System Features (KX-TG1822 only)
54
L You can hang up, or enter your remote
access code again and begin remote
operation.
Guide to answering
system settings
If the base unit is reset to its default settings
(page 37), the following answering system-
related settings will be reset.
Changing the number of rings
You can change the number of times the
phone rings before the unit answers calls.
You can select 2 to 7 rings, or “Auto”.
“Auto”: The unit answers after 2 rings when
new messages have been recorded, and
after 5 rings when there are no new
messages. If you call your phone from
outside to listen to new messages (page
52), you will know that there are no
messages when the phone rings for the 3rd
time. You can then hang up without being
charged for the call.
1 Press {j/OK}.
2 Select “Answer System”, then press
{>}.
3 Select “Settings”, then press {>}.
4 Select “Number of Rings”, then
press {>}.
5 Select the desired setting, then press
{>}.
6 Press {ih}.
For voice mail service subscribers
To receive voice mail and use answering
system properly, please note the following:
– To use the voice mail service provided by
your service provider rather than this
unit’s answering system, turn off the
answering system (page 49).
– To use this unit’s answering system rather
than the voice mail service provided by
your service provider, please consult your
service provider to deactivate your voice
mail service.
If your service provider cannot do this, set
this unit’s “Number of Rings” setting
so that this unit’s answering system
answers calls before the service
provider’s voice mail service tries to
answer your calls. It is necessary to check
the number of rings required to activate
the voice mail service provided by your
service provider before changing this
setting.
Selecting the caller’s recording
time
You can change the maximum message
recording time allotted to each caller, or set
the unit to greet callers but not record
messages.
1 Press {j/OK}.
2 Select “Answer System”, then press
{>}.
3 Select “Settings”, then press {>}.
4 Select “Recording Time”, then press
{>}.
Answering
system setting
Default
setting
Page
Answering
system on/off
Answer On page
49
Remote access
code
— page
52
Number of
rings
4 Rings page
54
Caller’s
recording time
3 Minutes page
54
Call screening On page
55
Message alert Off page
55
TG1810_1822AL(e-e).book Page 54 Tuesday, March 1, 2005 6:46 PM