Filter
Top Products
Base Unit Settings
35
If you select “No Ringing”, the base unit
will not ring during night mode.
1 Press {j/OK}.
2 Select “Base Unit Setup”, then
press {>}.
3 Enter “0000” (default base unit PIN).
L If you changed the PIN, enter it (page
36).
4 Select “Ringer Setup”, then press
{>}.
5 Select “Night Mode”, then press {>}.
6 Select “Ring Delay”, then press {>}.
7 Select the desired setting, then press
{>}.
8 Press {ih}.
Call options
Changing the recall time
Change the recall time, if necessary,
depending on the requirements of your
service provider or PBX.
1 Press {j/OK}.
2 Select “Base Unit Setup”, then
press {>}.
3 Enter “0000” (default base unit PIN).
L If you changed the PIN, enter it (page
36).
4 Select “Call Options”, then press
{>}.
5 Select “Recall”, then press {>}.
6 Select the desired setting, then press
{>}.
7 Press {ih}.
Setting pause length
Change the pause length, if necessary,
depending on the requirements of your
service provider or PBX.
1 Press {j/OK}.
2 Select “Base Unit Setup”, then
press {>}.
3 Enter “0000” (default base unit PIN).
L If you changed the PIN, enter it (page
36).
4 Select “Call Options”, then press
{>}.
5 Select “Pause Length”, then press
{>}.
6 Select the desired setting, then press
{>}.
7 Press {ih}.
Storing/changing emergency
numbers
These settings determine which phone
numbers can be dialled while the call bar
feature is on (page 31).
1 Press {j/OK}.
2 Select “Base Unit Setup”, then
press {>}.
3 Enter “0000” (default base unit PIN).
L If you changed the PIN, enter it (page
36).
4 Select “Call Options”, then press
{>}.
5 Select “Emergency No.”, then press
{>}.
6 Select a memory location, then press
{>}.
L If the memory location already
contains an emergency number, the
number is displayed.
7 Enter/edit the number, then press
{j/OK}.
L To erase an emergency number, press
and hold {C/T}.
8 Press {ih}.
TG1810_1822AL(e-e).book Page 35 Tuesday, March 1, 2005 6:46 PM