Filter
Top Products
3.3 Installation of the Hybrid IP-PBX PC Programming Software
134 Installation Manual
Starting the KX-TDA50 Maintenance Console and Assigning the Basic
Items (Quick Setup)
When you start the KX-TDA50 Maintenance Console with the Installer Level Programmer Code and connect
to the Hybrid IP-PBX for the first time after initialization (with the factory default setting), Quick Setup will
launch automatically. During Quick Setup, you will set up the basic items. For details about the basic items,
refer to "1.14.2 Quick Setup" in the Feature Manual.
1. Connect the PC to the Hybrid IP-PBX with a USB cable.
2. Start the KX-TDA50 Maintenance Console from the
Start menu.
3. "Information before programming" appears.
a. Carefully read this important additional information,
which includes updates to this and other manuals.
b. Click OK to close this window.
4. Enter the Installer Level Programmer Code (default:
INSTALLER).
The Programmer Code authorizes different
programming levels, and the Quick Setup is only
available when you start the KX-TDA50 Maintenance
Console with the Installer Level Programmer Code.
Note
There are 2 other Programmer Codes with limited
authorization: Administrator Level (default:
ADMIN), and User Level (default: USER).
5.
a. Click the check box to connect to the Hybrid IP-
PBX. Options will appear as shown here, on the
left.
b. Enter the system password for installer (default:
1234).
c. Select "USB", then click OK.
Note
To connect to the Hybrid IP-PBX via USB, the KX-
TDA USB driver must be installed on the PC, as
explained above in "Installing the KX-TDA50
Maintenance Console".
6. Follow the instructions of the Quick Setup wizard and
assign the basic items (Quick Setup).