Filter
Top Products
2.11 Starting the Hybrid IP-PBX
Installation Manual 127
3. Plug the AC cord into the AC adaptor, and then plug the other end into an AC outlet.
4. Turn on the power switch. The RUN indicator will flash.
Notes
• For safety reasons, follow the procedures as indicated when turning on the Hybrid IP-PBX.
• For safety reasons, do not stretch, bend, or pinch the AC cord and the DC cable of the AC adaptor.
5. While the RUN indicator is flashing, slide the System Initialize Switch back to the "NORMAL" position.
Depending on the configuration, initialization takes about 1 min to 3 min. If successfully executed, the
RUN indicator will stop flashing and stay lit.
All data will be cleared, and the Hybrid IP-PBX as well as all optional service cards (except for the IP-GW4
card) will be initialized to the default values. The DPTs should show the time as 01:00.
The data of the IP-GW4 card will not be initialized.
IMPORTANT
Use only the AC adaptor (Panasonic PSLP1244/Panasonic PSLP1434) and AC cord supplied
with the Hybrid IP-PBX, or the Additional AC Adaptor (KX-A236).
AC Adaptor
AC Cord
To AC outlet
Power Switch