Filter
Top Products
45
Cordless Telephone
Base Unit Settings
Selecting the Recall Time
You can change the duration of the recall time depending on the requirements of your
telephone company or PBX.
• The factory preset is “Type 2” (100 ms).
• You can access Telstra’s “EASY CALL” service by having the recall time set at 100
ms (this is the factory preset setting), and then follow Telstra’s “EASY CALL”
instructions to operate this service.
Selecting the Pause Time
You can select the pause time to 3 or 5 seconds, depending on your PBX requirements.
• The factory preset is “Short”.
Setting the Emergency Calls
Even if handset is in Call Bar Mode, you can make an emergency call.
• The factory preset is 000.
Follow steps 1 to 4 of Call Options on the previous page, then:
5
Select “Recall”.
6
Select “Type 1” (700 ms), “Type 2” (100 ms) or
“Type 3” (200 ms).
Follow steps 1 to 4 of Call Options on the previous page, then:
5
Select “Pause Time”.
6
Select “Short” (3 sec.) or “Long” (5 sec.).
Follow steps 1 to 4 of Call Options on the previous page, then:
5
Select “Emergency Call”.
6
Select “Emergency Call1” to
“Emergency Call5”.
7
Enter Emergency Call Number.
8
Press JOYSTICK.
500AL_e.book Page 45 Monday, June 30, 2003 3:17 PM