Filter
Top Products
47
Useful Information
Problem
The unit does not display
the caller’s name and/or
phone number.
A caller called you, but the
caller’s information was not
recorded in the Caller List.
The display goes to the
standby mode while viewing
the Caller List.
(REDIAL/PAUSE) does not
function properly.
You cannot have a
conversation using the
optional headset.
Previously programmed
information is erased.
If you cannot solve your
problem
Remedy
≥Other telephone equipment may be
interfering with your phone. Disconnect
it and try again.
≥Other electrical appliances connected to
the same outlet may be interfering with
the Caller ID information.
≥Telephone line noise may be interfering
with the Caller ID information.
≥If you receive two calls at the same
time, only one of the Caller ID
information can be recorded.
≥Do not pause for over 60 seconds while
searching.
≥The button has a double function as
either redial or pause. It will redial the
last number dialed if pressed at the
outset of a call (p. 20). If another
number has been dialed first, it will
operate as a pause button (p. 40).
≥Make sure that the optional headset is
connected properly (p. 43).
≥Press (SP-PHONE/HEADSET) to make or
answer a call.
≥If a power failure occurs, programmed
information may be erased. Reprogram
if necessary.
≥Call our customer call center at
1-800-211-PANA(7262).
≥Panasonic’s e-mail address for
customer inquiries:
consumerproducts@panasonic.com
for customers in the USA or Puerto Rico
ONLY
PQQX12879ZA-BM04 01.3.7 3:52 PM y[W 47