Filter
Top Products
“
Settings
14
Selecting the Line Mode
If a line is connected to a low voltage system such as a PBX, set to “B”. If
not, the line indicator will not operate properly. Both lines are preset to
“A”.
Make sure that the handset is on the cradle, the AC adaptor is
connected and the SP-PHONE/HEADSET indicator light is off.
1
Press (FUNCTION/EXIT).
2
Press (_) or (^) repeatedly until “SET
LINE MODE ?” is displayed.
3
Press (fl) OK/EDIT.
4
Press (_) or (^) to select the desired
line, “LINE1” or “LINE2”.
5
Press (fl) OK/EDIT (NEXT key).
6
Press (_) or (^) to select the desired
line mode.
7
Press (fl) OK/EDIT (SAVE key).
≥A beep sounds.
≥The display will return to step 2. To
program the other line, start from step 3.
To return to the standby mode, press
(FUNCTION/EXIT) or wait for
60 seconds.
≥You can exit the programming mode any time by pressing (FUNCTION/EXIT).
11:50
AM
11
/
24
SAVE AUTO# ?
11:50
AM
11
/
24
SET LINE MODE ?
11:50
AM
11
/
24
LINE1
1
=NEXT
LINE 1
11:50
AM
11
/
24
LINE2
1
=NEXT
LINE 1
11:50
AM
11
/
24
A
1
=SAVE
LINE 1
PQQX12879ZA-BM02 01.3.7 3:51 PM y[W 14