Filter
Top Products
83
Useful Information
For assistance, please call: 1-800-211-PANA(7262)
Problem
Previously programmed
information is erased.
“Recharge” is displayed,
“ ” flashes or the unit
beeps intermittently.
You charged the battery
fully, but “Recharge” is still
displayed and/or “ ”
continues to flash.
The IN USE/CHARGE
indicator light does not go
out after the battery has
been charged.
If you cannot solve your
problem
After Caller IQ is turned to
off, the unit is unable to turn
it back on and LCD shows
“Listen & follow
phone guidance.” without
any voice prompt announced
from the handset.
For more information about
Caller IQ
Remedy
•If a power failure occurs, programmed
information may be erased. Reprogram
if necessary.
•Charge the battery fully (p. 14).
•Clean the charge contacts and charge
again (p. 15).
•Install a new battery (p. 77).
•This is normal.
•Call our customer call center at
1-800-211-PANA(7262).
•Panasonic’s e-mail address for customer
inquiries:
consumerproducts@panasonic.com
for customers in the USA or Puerto Rico
ONLY
•Place the handset on the base unit, lift
the handset and try again.
•Check the settings (p. 85–87).
•If you cannot solve a problem, consult
openLCR (see below).
•Call openLCR’s customer service
department at 1-866-openLCR
(1-866-673-6527).
•openLCR’s web site:
www.openLCR.com