Filter
Top Products
Telephone
14
3 Dial the phone number, then press {C}
or {s}.
Note:
L Pressing @ 1 time creates 1 pause.
Press @ repeatedly to create longer
pauses. To change pause length, see
page 29.
Recording a telephone conversation
(KX-TCD580 only)
You can record your conversation while on
an outside call.
Important:
L Before recording a conversation, you
should inform the other party that the
conversation will be recorded.
1 Press * (centre of joystick) during a
conversation.
2 Press ,.
L A beep is heard and recording starts.
L A beep sounds every 15 seconds and
can be heard by the other party, but is
not recorded.
3 To stop recording, press Z.
Note:
L All persons using this device for recording
telephone conversations shall comply
with New Zealand law. This requires that
at least one party to the conversation is to
be aware that it is being recorded. In
addition, the principles enumerated in the
Privacy Act 1993 shall be complied with in
respect to the nature of the personal
information collected, the purpose for its
collection, how it is used and what is
disclosed to any other party.
L Recorded conversations are treated as
new messages.
L To listen to the recorded conversation, see
page 36.
L If message memory becomes full, “Full”
is displayed and recording stops. Erase
unnecessary messages (page 36).
Answering calls
1 Lift the handset and press {C} or {s}
when the unit rings.
L You can also answer a call by pressing
any dial key from {0} to {9}, {*}, {#},
or {INT}. (Any key talk feature)
2 When finished talking, press {ih} or
place the handset on the charger.
Vibration feature
When this feature is turned on (page 23), the
handset will vibrate to indicate an incoming
call.
Auto talk feature
You can answer calls simply by lifting the
handset off the charger. You do not need to
press {C}. To turn this feature on, see
page 26.
To turn the handset ringer off temporarily
When an outside call comes in, press B
or {ih}.
Note:
L This feature will not work for intercom calls
or when the handset is on the charger.
Handset locator
Using this feature, you can locate the
handset if it has been misplaced.
1 Press {x} on the top of the base unit.
L The base unit will page the handset
for about 1 minute.
L If the vibration feature is turned on
(page 23), the handset will vibrate to
indicate an incoming page.
2 To stop paging, press {x} on the base
unit or press {ih} on the handset.
KX-TCD560-580NZ(e).book Page 14 Tuesday, July 6, 2004 10:49 AM