Filter
Top Products
Preparation
11
Turning the power on/off
Power on
Press {ih} for about 1 second.
L The display will change to the standby
mode.
Power off
Press {ih} for about 2 seconds.
L The display will go blank.
Setting the date and time
Important:
L Confirm that the AC adaptors are
connected.
L Ensure that w is not flashing.
1 Press $ (centre of joystick).
2 Select t, then press , 2 times.
3 Enter the current day, month and year by
selecting 2 digits for each.
Example: 17 May, 2004
Press {1}{7} {0}{5} {0}{4}.
L If you make a mistake, use the joystick
to move the cursor, then make the
correction.
4 Enter the current hour and minute by
selecting 2 digits for each.
5 Press / repeatedly to select 12- or
24-hour time entry.
L 24-hour time entry is selected when
neither “AM” nor “PM” are displayed.
Example: 3:30 PM
Press {0}{3} {3}{0}, then press /
repeatedly until “03:30 PM” is
displayed.
6 Press ,.
7 Press {ih}.
Note:
L If a power failure occurs, set the date and
time again.
KX-TCD560-580NZ(e).book Page 11 Tuesday, July 6, 2004 10:49 AM