Filter
Top Products
“
41
Advanced Operation
To erase a stored number
Press and hold (CLEAR) in step 6 on page 40.
≥You can exit the programming mode any time by pressing (FUNCTION/EXIT/CH).
Setting the Voice Mail Tone
If your voice mail service sends a voice mail tone after a new message
has been recorded, set to “On”. “Voicemail” and “” will be displayed
when a message has been recorded in your mailbox. You will hear a
series of voice mail tones followed by a dial tone after pressing (TALK).
(Contact your service provider for details about your service.)
Set to “Off” if:
—you do not subscribe to a voice mail service,
—your voice mail service does not send a voice mail tone, or
—the unit is connected to a PBX.
Your phone comes from the factory set to “On”.
Make sure the handset is in the standby mode.
1
Press (FUNCTION/EXIT/CH).
2
Press (›) or (‹) repeatedly until the arrow
points to “Program”.
3
Press FWD/EDIT (fl) (Yes key).
4
Press (›) or (‹) repeatedly until the arrow
points to “Voicemail tone”.
5
Press FWD/EDIT (fl) (Yes key).
6
Press (›) or (‹) to select “Off” or “On”.
Press FWD/EDIT (fl) (Save key).
≥A beep sounds.
≥To return to the standby mode, press
(FUNCTION/EXIT/CH).
≥You can exit the programming mode any time by pressing (FUNCTION/EXIT/CH).
Ringer volume
1
Program
43
1
=Yes
Save mailbox#
1
Voicemail tone
43
1
=Yes
Voicemail tone
:On
43
1
=Save
Voicemail tone
:Off