Filter
Top Products
32
“
Troubleshooting
Problem
You cannot store a name
and phone number in the
phone book.
While programming or
searching, the handset
starts to ring and stops the
program/search.
The handset does not
display the caller’s name
and/or phone number.
The display goes to the
standby mode while viewing
the Caller List.
When a second call is
received during a
conversation, the unit does
not display the new caller’s
name and/or phone number.
[HANDSET LOCATOR]
does not function.
Cause and Remedy
≥You cannot store an item in the phone
book while the unit is in the talk mode.
≥Do not pause for over 60 seconds while
storing.
≥Lift the handset off the base unit and try
again.
≥To answer the call, press .
Start again from the
beginning after hanging up.
≥You need to subscribe to a Caller ID
service.
≥Other telephone equipment may be
interfering with your phone. Disconnect
it and try again.
≥Other electrical appliances connected to
the same outlet may be interfering with
the Caller ID information.
≥Telephone line noise may be affecting
the Caller ID information.
≥If a (separate) Caller ID box is
connected between the unit and the
telephone wall jack, disconnect the
Caller ID box or plug the unit directly
into the wall jack using the telephone
line cord included in the unit.
≥Do not pause for over 60 seconds while
searching.
≥The caller requested not to send his/her
information. See page 14.
≥The handset is too far from the base unit.
≥The handset is engaged in an outside
call. Wait until the IN USE/CHARGE
indicator light goes out.
[ /FLASH]