Filter
Top Products
Preparation
29
For product assistance, visit www.globarange.com
For A assistance, visit www.joip.com
Static setup N
If your local network does not use a
DHCP server for automatic IP address
assignments, turn the DHCP connection
mode off first. Then set the static IP
address and other Internet connection
settings corresponding to your local
network.
Turning the DHCP connection mode
off:
1 {MENU} i {#}{5}{0}{0}
2 {V}/{^}: “Off”
3 {SAVE} i {OFF}
Setting the static IP address and
other settings:
1 {MENU} i {#}{5}{0}{1}
2 Set the IP address and other
settings.
L Push the joystick down {V} or up
{^} to move between the
following 5 items.
L To move the cursor, push the
joystick right {>} or left {<}.
To correct digits, press {CLEAR}.
3 {SAVE} i {OFF}
L Wait until the STATUS indicator
on the base unit turns green.
When the STATUS indicator
lights in green, the setting is
complete. Confirm your A
number (page 30).
L When the STATUS indicator does
not light in green even if you wait
for a few minutes, see page 23.
IP
address
Enter the IP address in
this data field.
*1
L Set 4 numbers (0-
255) separated by
periods such as
“192.168.0.253”.
Subnet
mask
Enter the subnet mask
in this data field.
*1
L Set 4 numbers (0-
255) separated by
periods such as
“255.255.255.0”.
Default
gateway
Enter the default
gateway address in this
data field.
*1
L Set 4 numbers (0-
255) separated by
periods such as
“192.168.0.1”.
DNS1
(DNS
server 1)
Enter the DNS (Domain
Name System) server
addresses in each data
field.
*1
L Set 4 numbers (0-
255) separated by
periods such as
“172.23.0.100”.
DNS2
(DNS
server 2)
*1 There are some restrictions on these
entries. For example, “0.0.0.0” and
“255.255.255.255” are not available.
GT15xxC.book Page 29 Tuesday, July 24, 2007 7:17 PM