Filter
Top Products
me
Make sure your base is:
• Located within reach of a mains power socket and
telephone socket.
• At least 1 metre away from other electrical appliances, to
avoid interference.
• Not located in humid or damp conditions, e.g. in a
bathroom.
1 Connect the base power lead and the telephone line cord
to the back of the base. Plug the power adaptor into the
mains wall socket.
2 For multi-handset packs only: Plug the charger power
adaptor into the mains power socket.
3 On each handset: Slide the battery cover off and insert
the batteries supplied following the markings shown inside
the battery compartment, then slide the cover back on until
it clicks into place.
4 Place the handsets in the base/charger handset cradle
and charge for 15 hours before use.
5 Plug the telephone line cord into the wall socket.
Attaching the belt clip
With the back of the handset facing you, align the belt clip
with the two slots on the side of the handset and push
securely into place.
Your Oricom Touch phone is now ready for use
ATTENTION
Congratulations on your purchase of the Oricom Touch
Phone with its high tech touch sensitive keypad. The touch
panel is much more sensitive than a normal phone keypad
and provides very fast and responsive keying - however
like most new technology it takes a little getting used to.
To get the best use out of your Touch Phone
• Pick it up from the rear and cradle it in your hand.
• During use, avoid touching the keypad area unnecessarily
to prevent accidental triggering of the keypad.
• The keypad will automatically disable when you hold
the receiver to your ear. The idea being, to reduce the risk
of accidental keypad presses while the phone is held
against the side of your face.
QUICK SET UP
USING YOUR TOUCH PHONE AND BASE
Earpiece/Receiver
Display
Display with icons and blue backlight.
Up/Down
Press during a call to increase/decrease
earpiece volume. During standby use to
scroll Up or Down through the menu
options and through phonebook and
Calls log entries.
Talk
Press to make and receive calls.
Redial/Pause
Use to redial any of the last 20 numbers
called. Press to enter a pause in a number.
Alphanumeric keypad
Use to enter digits and characters.
When entering text, press repeatedly to
enter punctuation.
Recall/Cancel
For use with certain network services,
including Call Waiting. Press to delete an
incorrect character/digit. Press to return
to previous menu.
End
Press to end calls. Press to exit the menu
and return to standby mode.
Phonebook
Use to access the phonebook.
#/Conf
When entering text use to toggle between
lower and upper case. Press to start a
conference call.
Menu/Mute
Press to access the menu or confirm a
menu setting. During a call, press to mute
the microphone.
INT
Use to call another registered handset.
Find Handset (page)
Press to page/locate a misplaced handset.
(Located on the base behind the handset).
In Use/Message
LED indicator
Illuminates when
the line is in use.
Flashes when you
are connected to a
switcboard and you
have new voice
messages.
*