Oricom ECO710 Cordless Telephone User Manual


  Open as PDF
of 40
 
31
ANSWERING MAChINE SETTINGS
(ECO710 ONLY)
TROuBLEShOOTING
Troubleshooting
ALWAYS check first that:
Youhavefollowedallthestepslistedintheuser
manual to install and set up your telephone.
Allconnectorsarermlyinsertedintheirsockets.
Mainspowertothebaseunitisswitchedonatthe
socket.
Thehandset’sbatteriesarecorrectlyandsecurely
installed and are not run down.
Everyday use
"Icannotmakeoranswercalls"
• Ifthehandset’sdisplayisblank,itmayhavebeen
switched off. Press and hold the
END
keytoswitch
itbackon.
• Checkthatthebaseunit’smainspoweradapteris
plugged in and power is switched on.
• Thebaseunitneedsmainspowerfornormal
operationofthephone–notjustforchargingthe
batteries.
• Makesureyouareusingthetelephonelinecable
suppliedwithyourphone.Othertelephoneline
cablesmightnotwork.Movethehandsetcloserto
thebaseunit.
• Checkthebatterylevelsymbolonthedisplay.
• Ifitislow,replacethehandsetonthebaseunitor
chargerpodtorechargethebatteries.
• Switchoffpoweratthemainssocket,waitfora
shorttimeandthenswitchbackon.Thismaysolve
theproblem.
"Icannotmakeacall"
• IfthehandsetdisplayshowsKEYSLOCKED,
pressandholdthe*buttontounlockitbeforeyou
makeacall.
• Onlyonehandset(orthebaseunit)canbe
connected to the outside line at a time.
• Ifanotherhandsetisalreadyusingtheline,you
needtowaituntilithasnisheditscall.
"WhenIpressonthekeys,nothinghappens"
• Makesurethebatteriesarettedinyourhandset.
IftheBatteryLevelsymbolonthedisplayshows
‘low’,putyourhandsetbackonthecradleto
charge.
"WhenIkeyinanumber,itappearsonthedisplay,
butIcannotmakeanoutsidecall"
• Tryadifferentpositionforthebaseunit–
somewherehigherifpossible,orfurtherfromother
electrical equipment.
"The phone does not ring"
• Checkthatthebaseunit’smainspoweradapteris
plugged in and power is switched on.
 previous next