Filter
Top Products
4
4 Preparation
4.1 Turning the System On/Off
To turn the system on, press ANSWER ON/OFF button once.
The total number of recorded messages in two mailboxes
appears on the display. The system is now set to answer calls.
To turn the system off, press ANSWER ON/OFF button once.
‘–’ appears on the display.
4.2 Adjusting the Volume
Press VOL. button to increase the volume, or VOL. button to
decrease the volume. The system beeps when you press either
volume button. When the maximum volume is reached, the
system beeps three times.
4.3 Setting the Day and Time
You must set the day and time before the system will start to
record the day/time voice stamp on each incoming message.
The day/time voice stamp automatically defaults to Monday,
12:00 AM, when you connect the system to power. The date
and time do not advance until you set the correct day and time.
1. Turn on the system.
2. Hold down / TIME SET button for about two seconds,
then release it. The system announces “Monday”.
3. Repeatedly press / TIME SET button until you hear the
correct day.
4. Press / TIME CHECK button. The system announces
“twelve”.
5. Repeatedly press / TIME SET button until you hear the
correct hour.
6. Press / TIME CHECK button. The system announces
“0”.
7. Repeatedly press / TIME SET button until you hear the
correct minute.
8. Press / TIME CHECK button. The system announces
“AM”.
9. Press / TIME SET button to select “PM”.
10. Press / TIME CHECK button to confirm the setting. The
system announces the current day of the week and the time.
11. To hear the current day and time, press / TIME CHECK
button.