Filter
Top Products
10
5.6 To Reset
If an AC power failure occurs, or the AC power adaptor comes
out of the wall, your unit will shut down until the power is restored.
If your unit is not operating properly when the power is restored,
proceed with a unit reset.
1. Unplug the AC adaptor from the power outlet and telephone
line from the wall jack.
2. Replace the 9 volt alkaline battery with a fresh one.
3. Plug the AC adaptor back into the power outlet.
4. Plug the telephone line back into the wall jack.
5. Record a new outgoing announcement or you can use the
pre-recorded announcement.
6. Set the date and time.
6 Remote Operation
While you are away from your home or office, you can access
your system by remote operation. Use a touch-tone phone to
enter your remote operation security code.
6.1 Operating the System from a Remote Location
To use your system from a remote telephone, you must enter a
3-digit remote operation security code. The security code label
is located on the bottom of the unit.
1. Dial your phone number.
2. After the system answers, wait for the outgoing message
and the beep tone. Enter your remote operation security
code. The unit will emit two beeps to indicate the code was
entered correctly.
3. Enter a remote command. See “Remote Commands”.
Notes:
• If the memory is full, the system will answer calls after 10
rings, then announce “memory is full” and emit three short
beeps. You can then enter the 3-digit remote code to control
the unit.
• If you do not have CPC service and you hang up while the
system is playing back messages, the system might not
recognize that you hung up.
• If someone calls while the system is playing the messages
(in remote operation), the caller hears a busy signal.