Oricom AM100 Answering Machine User Manual


 
9
1. To listen to Mailbox 1 messages, press MAIL 1 PLAY/STOP
button. To listen to Mailbox 2 messages, press MAIL 2 PLAY/
STOP button, the Message Counter will display the message
number being played.
Note: If there are no messages, the display shows “0” and
you will only hear either “mailbox 1” or “mailbox 2” when you
press the corresponding mailbox PLAY/STOP button.
2. The system plays each new message in sequence and
announces the day and time it was recorded.
3. During message playback:
Press / TIME CHECK button to repeat the current
message.
Hold down / TIME CHECK button for about two
seconds to repeat the previous message.
Press / TIME SET button to skip forward to the next
message.
To stop message playback at any time, press PLAY/STOP
button.
4. After playing all messages, the system beeps and saves
the messages. The total number of messages in two
Mailboxes appears on the display.
5. To replay all messages, press the corresponding mailbox
PLAY/STOP button.
5.5 Deleting Messages
You can delete messages individually during playback, or all at
once after playback.
To delete an incoming message (after listening to it), press
ERASE button once during playback, “E” appears on the display.
To delete all messages in the corresponding mailbox after
playback, hold down ERASE button for about two seconds. “E”
is flashing rapidly on the display, press the corresponding mailbox
button. The system beeps and all messages in the corresponding
mailbox are deleted.
Note: If you hold down ERASE button before playing back all
messages, the system beeps. You cannot delete the new
messages until you play them all back.