Filter
Top Products
Installing the Base Station / 23
T7406 Installation Guide
Before you start
• Ensure there is an AC power outlet within 1.5 meters (5 feet) of the
base station location.
• Ensure that the telephone lines from your system have been installed
to the base station location.
Mounting and Connecting the Base Station
Follow these steps to mount and connect each base station.
1. Use the mounting bracket as a template to position the base
station and mark the screw positions.
2. Use screws to attach the mounting bracket to a wall or ceiling.
3. Set the base station dip switches, located on the back of the base
station, to the required ISM frequency band.
4. Connect the telephone lines to the base station.
• On the first base station you install,
set the dip switches to operate in the
upper half of the ISM band. From left
to right, set to Down-Up-Down.
• On the second base station, set the dip
switches to operate in the lower half
of the ISM band. From left to right,
set to Down-Down-Up.
a. Plug one end of the line cord into a
telephone jack on the base station.
b. Connect the other end into a telephone
port on the system equipment.
Note:Connect a maximum of three
TCMs per base station to the system.
c. Plug the small end of the power
adapter into the back of the base
station.
d. Plug the other end into an AC outlet.
Note:A red light flashes continuously
on the base station when powered.
Upper half
ISM Band
1 2 3
Lower half
ISM Band