Filter
Top Products
Setting Handset Features / 33
T7406 Installation Guide
If you are assigning the first handset to a new base station (which has
no security code), continue with the following steps:
9. The display shows
4. Set S.S. Code :
, press
NEXT
to get ready to
send the security code to the base station.
The display shows
5. Send S.S. Code
.
10. Unplug the AC power adapter connected to the base station, and
plug it back in again.
11. Within 15 seconds, press and hold the
OK
button for five seconds.
This sends the Security Code to the base station. The display
shows
Send OK!
and you hear a beep when the transfer is
successful.
Note: If the Security Code transfer fails, the display shows
Send
Error!
To correct this, repeat steps 9 and 10.
12. Press the Options button to exit the Option menu.
The display changes to show the date and time.
Configure the next handset to the base station
Configure the second and third handsets to the base station using these
procedures:
1. Follow the steps in Configuring the Handset ID Number
on page
30. Ensure you enter a different handset ID number (1, 2, or 3)
for each handset you configure.
2. If you want to change the handset ID password, continue with the
steps in Changing the Handset ID Password
on page 31.
3. Once you have assigned a Handset ID #, continue with Assigning
the Security Code on page 32 up to and including step 8.
Setting Handset Features
After you identify the handsets to the base station, you can set up the
handset features:
Ring Type
To assign the ring type: