Filter
Top Products
10 Getting started
N0009103 1.0
Setting up the WLAN Handset
This section describes the following initial setup options for your WLAN Handset:
• “Select Ring Type” on page 10
• “Select Noise Mode” on page 11
• “Enter Extension” on page 11
• “Set up Push-to-Talk” on page 12
• “Adjust ringer volume” on page 12
• “Adjust speaker volume” on page 12
• “Silence the ringer” on page 13
Select Ring Type
The Ring Type option enables you to set the WLAN Handset ring tone for the three different
ringers: Telephone, Auxiliary 1, and Auxiliary 2. Auxiliary 1 and Auxiliary 2 are reserved for
future use.
Select the Ring Type:
1 Press when in the standby state.
2 Press the Up and Down buttons to scroll through the menu and highlight
Ring Type.
3 Press the Select button (or
OK) to select Ring Type.
4 Press the Up and Down buttons to scroll through the menu and highlight
Telephone.
5 Press the Select button (or
OK) to select Telephone.
6 Press the Up and Down buttons to scroll through the menu and highlight one of the following
settings:
• Normal: Produces an audible ring (default).
• Vibrate: Vibrates.
• Vib/Norm: Vibrates for six seconds, then rings.
7 Press the Select button (or OK
) to select the setting.
8 Do one of the following:
• Press UP
to return to the previous menu and set another option.
• Press to exit all menus and return to the standby state.
You can also press Exit
from the top-level menu to exit the menu and return to the active
(off-hook) state.