Filter
Top Products
Configuring the CallPilot 100/150 15
CallPilot 100/150 Quick Start Guide
Configuring the CallPilot 100/150
After you have initialized the CallPilot 100/150, you can begin configuring the CallPilot features.
For information about how to configure the CallPilot 100/150, refer to the CallPilot Manager Set
Up and Operation Guide or the CallPilot 100/150 Telephone Administration Guide.
Additional information
For more information about installing the CallPilot 100/150 (such as troubleshooting) or how to
install two CallPilot 150 units on one KSU, refer to the CallPilot 100/150 Installation and
Maintenance Guide.
11. Press CHNG
to toggle the setting between NVM and CP.
If you choose NVM, the mailbox users will see and hear Norstar
Voice Mail prompts when they use their mailboxes.
If you choose CP, the mailbox users will see and hear CallPilot
prompts when they use their mailboxes.
12. Press NEXT
.
13. Press OK
.
This message appears on the display.
Initialization takes about three seconds. When complete, the display
shows: System ready and Exit.
After the initialization programming is completed, the display
automatically returns to the time and date.
Primary UI:NVM
CHNG NEXT
System config
RETRY OK
Configuring...
System ready
Exit