Filter
Top Products
10 Initializing the CallPilot 100/150
N0008008 02
2 In the URL address box, type the CallPilot 100/150 IP address.
For example: HTTP://192.168.110.10
The Quick Install Wizard screen appears. Depending on your system, this can take several
minutes.
3 Configure the Quick Install parameters for a CallPilot 100/150 according to following table.
Note: You must include HTTP:// to access CallPilot Manager.
Table 3 Quick Install Wizard parameters for a CallPilot 100/150
Field name Description
IP Address Enter the IP Address or Fully Qualified Domain Name (FQDN) for the CallPilot 100/150. If you do
not know the IP Address or FQDN, contact your network administrator.
This is the IP Address FQDN you will use to access the CallPilot 100/150 using CallPilot
Manager.
Changes to the IP Address take effect when you reboot the CallPilot 100/150.
If this is a re-install, the IP Address shows the current settings, not the factory default.
Subnet Mask Enter the Subnet Mask for the CallPilot 100/150. If you do not know the Subnet Mask, contact
your network administrator.
Changes to the Subnet Mask take effect when you reboot the CallPilot 100/150.
If this is a re-install, the Subnet Mask shows the current settings, not the factory default.
Primary DNS Enter the IP Address of the Primary DNS server that CallPilot 100/150 uses. If you do not know
the IP Address, contact your network administrator.
The Primary DNS server allows you to use domain names, such as www.nortelnetworks.com,
instead of IP addresses when accessing a site.
Note: If you do not use DNS, leave this box blank. CallPilot applications, such as Digital
Networking, can use a DNS server even if you leave this box blank.
Secondary DNS Enter the IP Address of the Secondary DNS server that CallPilot 100/150 uses. If you do not
know the IP Address, contact your network administrator.
CallPilot 100/150 uses the Secondary DNS server if it cannot contact the Primary DNS server or
if the domain name is not listed in the Primary DNS server.
Note: If you do not use DNS, leave this box blank. CallPilot applications, such as Digital
Networking, can use a DNS server even if you leave this box blank.
Default Gateway Enter the IP Address of the default next-hop router. If you do not know the IP Address, contact
your network administrator.
Note: If you do not require a next-hop router, leave this box blank.
Attendant DN Enter the extension number of the CallPilot attendant.
Warning: If you enter an FQDN in the IP Address box, you must ensure that the
FQDN for the CallPilot 100/150 is in the same subnet as is specified by the Subnet Mask
and the Default Gateway IP address. If you enter an FQDN that is not in the same
subnet, you may cause the CallPilot 100/150 to continuously reboot. To correct this
problem, use the serial interface to change the IP address of the CallPilot 100/150. For
more information, refer to “Changing the IP address using a serial cable” on page 7.