Filter
Top Products
14 Initializing CallPilot 100/150 using a telephone
N0008008 02
Configuring the CallPilot 100/150 initial parameters
To configure the CallPilot 100/150 initial parameters:
1. Press ≤·°‹.
This is the default System Administration feature code. If your
system does not use the default feature codes, enter the System
Administration feature code you determined earlier.
2. Enter ¤flfl‹›› (CONFIG) and press OK.
3. Press Y
if you want the display and voice prompts to be available in
two languages.
Press N
if you want the display and voice prompts to be available in
one language.
When you choose N (No) for the Bilingual option, step 6 is not
required and the system automatically goes to step 7.
4. Press the button for the language you want as the Primary
Language.
5. Press CHNG
to toggle the settings between Y for Yes, or N for No.
6. Press NEXT
.
When you choose N (No) for the enable Group List option, steps 9
and 10 are not required and the system automatically goes to step
11.
7. Press CHNG
to enter a new Group List leading digit.
The Group List leading digit can be any number from 0 to 9. Special
Mailbox numbers automatically begin with 1, so if you select a Group
List leading digit of 1, the Special Mailboxes will begin with 2. The
Group List Leading Digit cannot be the same as the first number of
any mailbox.
8. Press NEXT
.
9. Press CHNG
to toggle the settings between Y for Yes, or N for No.
10. Press NEXT
.
Pswd:
RETRY OK
Bilingual?
YES NO
Primary lang?
ENG FRE
Group lists? Y
CHNG NEXT
Leading digit: 9
CHNG NEXT
CallPilot UI:Y
CHNG NEXT