Filter
Top Products
Introduction
12
• Use the following call modes:
— Direct Outbound—This is the basic mode. You can initiate calls
directly from your Nokia device to other parties by dialing or
selecting friends to call. This direct mode uses an Outgoing Call
Service DN to access the MCG 3100 in the enterprise. The
MCG 3100 then dials the number entered in the MCC 3100 using
the enterprise dial plan.
— Call-me-First—This is a call option in the advanced mode, and
you can change many other calling options (for example,
outgoing prefix, calling locations). Call-me-First calls take two
steps to complete. First, the MCG 3100 calls you at a chosen
location. After you answer, the MCG 3100 initiates the call by
calling the number you entered in the MCC 3100 using the
enterprise dial plan.
For more information, see “Call modes” on page 49.
Note: You must configure your Outgoing Call Service DN in the
MCC 3100 settings before you can use the Direct Outbound call
mode. Your system administrator provides the Outgoing Call Service
DN to allow direct MCC 3100 calling from your Nokia device.
For more information, see “Initial configuration” on page 23.
Before you begin
Before you install the MCC 3100 application, complete the following
checklist:
• Install the Nokia PC Suite software and ensure it is working properly.
• Become familiar with navigation and data entry methods for your
Nokia device.
System and network requirements
The MCC 3100 for Nokia has the following system requirements.